View and Download Hioki instruction manual online. DIGITAL M? HiTESTER. Test Equipment pdf manual download. Hioki Pdf User Manuals. View online or download Hioki Instruction Manual. Hioki Digital M-Ohm HiTester, Hioki – on Sale at the Test Equipment Depot. Slow: less than seconds (at manual ranging). Sampling rates, Fast: .

Author: Balkree Gojar
Country: Bahamas
Language: English (Spanish)
Genre: Photos
Published (Last): 26 December 2005
Pages: 302
PDF File Size: 18.69 Mb
ePub File Size: 17.55 Mb
ISBN: 787-4-89470-321-7
Downloads: 6875
Price: Free* [*Free Regsitration Required]
Uploader: Nejinn

Chapter 5 Other Functions Queries measurement value and judgment result. Proceed with discharge by following instruction in 4. Controls And Functions Determining Delay Time Sending Measurement Data To Pc Multiple query commands can also be in a line.

If the response messages overflow this limit of bytes, a query error is generated, and the output queue queue is cleared.


The Insulation Tester ST delivers the fastest insulation resistance testing in the industry, meeting all the requirements of production lines thanks to rapid takt times. When ON is set Displays countdown time from designated time. LOAD Loads test conditions Replace the test probes specified by Hioki.


Maintenance And Inspection Blinks during discharging buildup in tested object. Each setting display blinks during setting status. Notes On Use Setting Judgment Beep Sound Page Queries measurement value and judgment result.

Hioki 3154 Manuals

Sampling rate is set with FAST. Saving Test Conditions Got it, continue to print.

Definition of test duration: Communication conditions are not configured properly. Loading Test Conditions RANGe Set analog output to output in all measurement resistance ranges or in each range display area.

After completing testing, analog output continues to output and hold final voltage. Test duration is 10 seconds. The use of optional Switched Probe lets you to operate the ST while holding the probe. DCV terminal, refer to the chart below for external DC power supply to be connected for another direct loading and output signal voltage, output current. Setting And Verifying Timer D-sub 9 pin, male Signal DELay Sets delay time.

GND terminal is connected with power supply cord ground lead.


Hioki Digital M-Ohm HiTester, Hioki – at the Test Equipment Depot

Powering On and Off the Unit See 2. Gallery No results were found. Test 3514 cannot be changed during testing. Rear Connect test probes.