dbx DriveRack • User guide • Download PDF for free and without registration !. DriveRack ®. Features. dbx® Compression and Limiting. < Graphic. Get the owner's manual at · products/driverack# documentation or scan the code to the right with a QR scanner app on your mobile.

Author: Voodoomuro Vudokazahn
Country: Argentina
Language: English (Spanish)
Genre: History
Published (Last): 11 August 2006
Pages: 161
PDF File Size: 3.90 Mb
ePub File Size: 10.47 Mb
ISBN: 962-1-92976-449-2
Downloads: 70711
Price: Free* [*Free Regsitration Required]
Uploader: Sagami

The following section will provide you with descriptions and explanations of all parameters within the DriveRack Connect the outputs of the DriveRack and run to the selected speaker amplifier.

You can login to do that!

Pdf Download | dbx DriveRack User Manual (84 pages)

The Soft Reset resets all operating parameters except user programs. Gain structure refers to aligning the gain of each device so that they dbs clip at the same point, and the noise floor of the entire system is at its absolute minimum.

To instantly access an effect module, simply press the corresponding button in the button array for drvierack desired module.

From program mode, press the EQ button to reach the EQ module to be edited. Connect the outputs from the mixer to the inputs of the DriveRack.

Input 2 Level -Inf to 20dB Dbbx the input level of input 2. This file is downloadable free of charge: Please, do not make a copy of the downloaded manual and do not offer to sell it, just use personally to repair defective appliance!



To wire in series each Zone Controller must have an identification or zone number chosen using the DIP switches on the side of the controller see diagram A. Don’t have an account? Zc-zone Controllers RJ connectors, the Zone Controllers offer an easy to program and use remote control surface.

Warranty In no event shall dbx or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control. Defining The Driverack DriveRack Driveraco for other manual? Pressing the DATA wheel again and rotating it then allows you to assign this binary switch combination to a program to be loaded.

The Hard Reset Procedure will reset all programmable information back to the factory defaults. After expiration of the warranty, a reasonable charge will be made for parts, labor, and packing if you choose to use the factory service facility.

Successive presses of the Data wheel will select effect parameters within the currently selected page. Zc Setup Output 5. These free programs can be found on this page: Level 9 to 12 dB Sets the overall gain of the high shelf parametric 4. Up to six ZC panels can be connected to a DriveRack Connections When setting up the DriveRackmake connections as follows: You could suffer a fatal electrical shock!

Your local dbx sales and service office or If you want to dispose this product, do not mix it with general household waste. The Auto-EQ can be used to adjust your system to compensate for room effects, and adjust the response of the entire system to your liking.


To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Master manul -Inf to 20dB This parameter is used to control the overall level of the mixed input signals. If you are not familiar with electronics, do not attempt to repair!

Successive presses of the Other button will move you to each of the various insert modules available. The Utility Menus will appear as follows: DB-9 female-to-female null modem cable Important Note!

DBX Driverack 260

The upper left-hand corner of the display indicates what Crossover type is currently selected. Adjust the individual parameters for the system by pressing the Processing Module buttons. This lets you choose the exact knee bdx is needed for the dynamic effect you are looking for. RJ connectors, the Zone Controllers offer an easy to program and use remote control surface.

Pressing the Data Wheel will select the effect parameter to be edited.